<!doctype html public "-//w3c//dtd html 4.0 transitional//en">
<html>
Randall Gibson wrote:
<blockquote TYPE=CITE>&nbsp;
<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; Basically, I am trying to
say is do you think it is a Linux problem
<br>?? Re-setting cable modem to fix it sounds like modem problem. Or its
<br>configuration. Did this setup work fine under Windows, and problem
started
<br>when you installed Linux ??
<br><a href="http://www.ntlug.org/mailman/listinfo/discuss"></a>&nbsp;</blockquote>
I think it is a linux problem. I notice a lot of colisions on my hub when
I am in Linux on my laptop. Never had that be=fore I upgraded to RH7.1.
My eth0 also fails upon bootup, looks like it is trying to initialize before
cardservices, but when I get into the gui, I can access the internet. I
only have the problem downloading large files, anything that takes up a
lot of bandwidth. Like I said, I get a lot of collisions on the hub, and
I dont get this when I&nbsp;am on the same machine in windows. I have a
10/100 + 56K Linksys card, and am using pcnet_cs module for it as recommended
on Linksys "Limited" Linux support page. I was wondering, if for some reason
linux was running the card as a 100 tx instead of 10 tx would that cause
a problem? I only have a 10meg hub currently.
<br>&nbsp;</html>